In this tutorial we will make a coffee cup out of polygons.
Select the Modeling section of Maya, choose from upper left, status line.
Select Create->Polygon Primitives->Cylinder->
Set the Axis to Y
Set the Radius to 2
Set the Height to 4
Set the Axis divisions to 10
Set the Height divisions to 3
Set the Cap divisions to 0
Select by component type and make sure the faces button is pushed in; this will allow you to select faces. Select the top face.
Select Edit Mesh->Extrude
Click the red box at the end of the red arrow of the extrude manipulator to change to scale mode. Select the light blue box at the center of the manipulator and scale down the face a little.
Select Edit Mesh->Extrude (again)
Click the blue arrow and pull the polygon face down into the cup close to the bottom.
Go to the front view and press the button to show vertices or use the right mouse to select vertex. Drag to select around the second row of vertices and drag them up to just below the top edge. Drag a window around the third row of vertices and drag them down to just above the bottom edge.
Go back to the perspective view and rotate the model until you are looking at a face perpendicular to an axis.
Select Mesh Tools->Multi-Cut
Find the face perpendicular to the Z axis.
Hold Shift and click on the left edge and drag down until the point snaps to the midpoint of the segment then release. Now click on the right edge and drag down until the point snaps to the midpoint of the segment then release. Hit enter.
Select the Select Tool to stop the Multi-Cut tool.
Turn on faces again by pressing component type and the faces button .
Select the two new faces and select Edit Mesh->Extrude.
Click red colored box to show the center scale box.
Scale them down by using the center scale box icon.
Click Keep Faces Together to Off in the small dialog box.
Select another tool, such as the Move tool to stop this tool
Deselect the bottom face (while holding shift) and select Edit Mesh->Extrude. Pull the polygon out a little in the Z direction and click the blue circle to activate rotation and rotate the polygon forward and down a little
Extrude again and pull the polygon forward and rotate it forward a little. (Hit g hot key to run the tool again.) Extrude once more and rotate the face so that it is parallel with the grid, you may have to scale it a little so that it stays in proportion.
Extrude faces one more time and tilt the new face in towards the side of the cup. When you get it where you want it hit the delete key to remove the face at the end. We need to delete this face in order to stitch the cup handle back onto the cup body.
Select the face on the coffee cup where the handle will join the side of the cup and Extrude it out towards the handle. With the last face you just extruded still selected hit the delete key. Now we are ready to stitch the handle
Select Mesh Tools->Target Weld
Use the left mouse to select a corner. Hold down the mouse and pull over to the edge you want to match up to. This also works with edges, etc.
Now the rough body of the cup is complete. Move the points of the handle to get a more desirable shape. Select your object and select Mesh->Smooth to smooth your polygon shape.